Nerf Dead Space Plasma Cutter

Here is a project I did for the fun of it going back to my Nerf gun bashing roots. Underneath this plasma cutter is a Nerf Recon that got a Dead Space makeover. I simply made a few elements from scratch using varied thicknesses of styrene and attached them to the shell of the gun. I made sure I did this in such a way that the slide of the gun still functioned so that it could be pulled back and cocked. Once again I am unfortunately lacking in progress shots.

_DSC0011

Skylow Dead Space Plasma Cutter

Skylow Dead Space Plasma Cutter

Skylow Dead Space Plasma Cutter

Skylow Dead Space Plasma Cutter

The magazine ended up being the attachment point for the elements on the underside of the gun and is able to be removed to load darts.

Skylow Dead Space Plasma Cutter

Skylow Dead Space Plasma Cutter

Skylow Dead Space Plasma Cutter

In the end this project was just fun and cool enough to make the cut.

Thanks for reading!

1 Response

  1. Baird August 3, 2014 at 3:59 pm #

    Hey just wondering what kind of spray paint you used for the gun to give it such a good look?

Leave a Reply to Baird Click here to cancel reply.